NOTE: Weld collar 15050375 is not recommended with a 1-inch float extension. Follow above instructions for installation directly into the wall of the pressure vessel.The weld collar, P/N 15050375, must be welded into the wall of the pressure vessel according to code standards and good welding practices.Verify all pressure connections are tight before pressurizing the system.įloat Clearance Reference Tables Pipe Data – Table 2 Nom.Ensure all electrical connections are insulated and the cover is fully installed before reconnecting electrical power.The electrical connection is ½ inch14 NPT. Make the electrical wiring connections according to appropriate wiring diagrams for the alarm or shutdown system to be used.NOTE: The word TOP is cast into the top of the body. Verify that the electrical connection is positioned at the bottom.Screw the unit directly into the threaded connection in the wall of the pressure vessel. Before installing the level switch, use of a pipe thread sealant is recommended.Make certain the float is tightly screwed onto the counter-balance.INSTALLATION SHOULD BE ACCOMPLISHED BY QUALIFIED PERSONNEL ONLY. Refer to tables 1 and 2 for application data. Pressure Vessel Installation Direct Installation into the Wall of the Pressure VesselĬAUTION: Determine that the float travel is not obstructed by the coupling in the vessel wall, internal baffles, etc. NPT 15700799 External Float Chamber Operating Pressure: 2000 psi (13.8 MPa) Operating Temperature: 400° F (204° C) 15050375 Weld Collar 15000892 1-inch Float Extension Kit MLS DiagramĪll models of the MLS Series install the same and share dimensions other than Test Button. This manual covers the models and accessories listed below. Canadian Registration Number: MLS-020, MLS-015: 0F12013.2 C (all provinces and territories) CSA approved MLS Series Models and Accessories. All models screw directly into the scrubber or can be mounted via external float chamber.Improved design provides better dependability with reduced number of moving parts.MLS Series rated for 2000 psi (13.8 MPa) working pressure.CF8 (304) cast stainless steel body and 304 stainless steel float.Designed for harsh gas compressor scrubber applications.Clean magnet design virtually eliminates iron filing accumulation onto the magnet.The MLS Series connects directly into the scrubber wall and can be used with an FW Murphy weld collar or FW Murphy external float chamber. MLS Series Liquid Level Switches with 2 inch NPT and 1-1/2 inch NPT mounting are float activated to operate an electrical SPDT reed switch for alarm or shutdown of an engine or electric motor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |